Methoden voor het selecteren van IGBT-modules

Jul 03, 2026

Laat een bericht achter

Selectie
The voltage rating of an IGBT module is closely related to the input power supply (mains voltage) of the device in which it is used. De relatie wordt weergegeven in de onderstaande tabel. During operation, as the IGBT module's collector current increases, the rated power loss also rises. Simultaneously, switching losses increase, leading to greater heat generation; therefore, the rated current of the selected IGBT module should exceed the load current. Dit is vooral belangrijk voor hoogfrequente schakeltoepassingen, waarbij verhoogde schakelverliezen en warmteontwikkeling het noodzakelijk maken dat de component tijdens de selectie wordt verlaagd.

 

Meting
Static Measurement: Set the multimeter to the ×100 range. Connect the black probe to terminal 1 and the red probe to terminal 2; de weergegeven weerstand moet oneindig zijn. Swap the probes; the displayed resistance should be approximately 400 ohms. Using the same method, connect the black probe to terminal 3 and the red probe to terminal 1; de weergegeven weerstand moet oneindig zijn. Swap the probes; the displayed resistance should be approximately 400 ohms. If these conditions are met, the two units of the IGBT show no obvious faults. Dynamic Test: Set the multimeter to the ×10K range. Sluit de zwarte sonde aan op klem 4 en de rode sonde op klem 5. Sluit vervolgens de zwarte sonde aan op klem 3 en de rode sonde op klem 1; de weerstand moet 300–400 ohm zijn. Swapping the probes should also yield a resistance of approximately 300–400 ohms, indicating that this IGBT unit is functional. Test the IGBT between terminals 1 and 2 using the same method; if the results match the above, that IGBT unit is also functional. Stel de multimeter in op het R×10KΩ-bereik. Connect the black probe to the IGBT's drain (D) and the red probe to the source (S); de wijzer van de multimeter moet oneindig aangeven. Briefly touch both the gate (G) and the drain (D) with your finger; this triggers the IGBT to conduct, causing the multimeter pointer to swing toward the lower resistance range and hold its position. Next, simultaneously touch the Source (S) and Gate (G) terminals with your fingers; the IGBT will switch to the cut-off state, and the multimeter needle will return to the "infinity" position. At this point, you can determine that the IGBT is functional. Note: Before performing a second measurement, you should momentarily short-circuit the Source (S) and Gate (G) terminals. Any analog multimeter can be used to test an IGBT. When testing, ensure the multimeter is set to the R×10kΩ range; instellingen onder R×1kΩ gebruiken een interne batterijspanning die te laag is om geleiding in de IGBT te activeren, waardoor het onmogelijk wordt om de toestand ervan te verifiëren.

Aanvraag sturen
Aanvraag sturen